Set of 2 largest forming block punches. Forming block not included. I had this forming block for a LONG time before Gil (Twin Oaks Engineering) made these delrin punches for it. The block is a standard one that can be purchased from a variety of jewelry supply places. I had tried a number of different kinds of punches, using a rawhide mallet to work the metal into the form, assorted wood dowels, metal forms, and who only knows what else!
I asked Gil what he would recommend and he came up with these delrin punches. He sized the punches accurately to allow up to an 18 ga. sheet of metal to be formed with an exact fit between the block and the punch. Thinner sheets can be formed easily, and there isn’t so much extra room that the sheet would form unevenly.
These punches make my forming block so much easier and faster to use – and the end result is always even and consistent. Can’t ask for much more than that! Click on link or image at right to download/view an instructional video
on how to use these punches - please note: video is quite large so be patient while it downloads to your computer...
Made of sturdy delrin
Two blocks sized to accommodate up to 18 ga. sheet
This listing is for two large punches. (Punches ONLY – Block NOT included)
Shipping fees for this item are $12 for a USPS Priority Mail Flat Rate Box for the USA only. If you are an international customer, will will contact you after you place your order with any additional fees that may apply and be added to your total.